DT2821 INDEX:

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

A:

ADC Coding - Straight Binary, Offset, or 2s Complement
Address Parameter A:
AUTOEXEC.BAT ignored
Averager Remote Control Bit
Averager Remote Parameter Preset

B:

Base Address Jumpers (table)
Bipolar versus Unipolar Jumpers
Board Menu Controls

C:

Channel Control
Channel Preset Parameter C:
Configuration Parameters
Connector Pinout Diagrams
Conversion Speed Parameter S:
CPU Speed versus Maximum Sample Rate, Table

D:

Differential versus Single-Ended Jumpers
Digital I/O Preset
DDisk Remote Control Bit
DDisk Remote Parameter Preset
DMA Level (D: Parameter)

E:

F:

F: Parameter (Help File Omit)
Factor, STIM3 Oversampling
Factor, STIM3 versus Performance (table)
Features and Models

G:

Gain (Range) Control
Gain (Range) Preset Parameter R:
Gain x2 Jumpers

H:

Harmonic Number using External Pacer
Help File Parameter F:
Hypersampling, Performance Table
Hypersampling, using STIM3

I:

Input Range Control
Input Range Preset Parameter R:
Introduction - DT2821 Features
IRQ (Interrupt Request) Parameter I:

J:

Jumpers, ADC Coding
Jumpers, Base Address (table)
Jumpers, Bipolar versus Unipolar
Jumpers, DAC Output Range (table)
Jumpers, DMA Level (table)
Jumpers, Gain x2
Jumpers, IRQ (table)
Jumpers, Single-Ended versus Differential

M:

Machine Vibration - Harmonic Number
Maximum Sample Rate, Determining
Maximum Sample Rates versus Mode and CPU Speed (table)
Model Parameter M:
Models and Features Supported

O:

Output Range, DAC
Oversampling, Performance Table
Oversampling with STIM3

P:

Pacer, External Preset Parameter S:En
Pacer, Timer / External Control
Parameters, Configuration
Parameter Overview
Performance Table
Pinout, J1 Connector
Port I/O Preset Parameter P:
Pulse Output Bit

R:

Range Control, Input
Range Preset Parameter R:
Ranges, DAC Output
Remote Control Bit, Averager
Remote Control Bit, DDisk

S:

Sample Rate, Determining Maximum
Sample Rate versus Mode and CPU (table)
Simultaneous ADC and DAC Feature
Simultaneous ADC and DAC Performance
Single-Ended versus Differential Jumpers
Speed Parameter S:, ADC and DAC
STIM3 DigOut vs Pulse Outputs
STIM3 Oversampling Factor

T:

Trigger Pulse Output Bit
Trigger, External
Trigger, External Parameter Preset
Trigger, Sweep vs Conversion Terminology

U:

Unipolar versus Bipolar Jumpers

W:

Wiring Diagram, J1 Connector

• Back to DT2821 Index.
• Back to DT2821 contents.
• Back to Daqarta Board Drivers.
• Daqarta for DOS Help contents.
• Daqarta for DOS Index.
• Daqarta home page.
• Daqarta download options.
• Free Registration

Questions? Comments? Contact us!