Burst Time Modulation Base Value Control

Macros: BurstLag, BurstRise, BurstHigh, BurstFall, BurstCycle, TrainCount, TrainCycle

This is a mirror of the Burst control used to invoke this modulation dialog. For example, if you clicked the button labeled High to the left of its control, this will be a mirror of that control. It will still function as a normal control even if the above Mod button is toggled off.

Macro Notes:

Use the BurstLag, BurstRise, BurstHigh, BurstFall, BurstCycle, TrainCount, or TrainCycle commands to change the base control as well as this mirror copy. You do not need a corresponding Lag., Rise., High., Fall., Cycle., Count., or Train. prefix here. For example, L.1.BurstLag=10 will set Left Stream 1 Burst Lag to 10 samples (or seconds) directly.

Note that the value you provide for all these controls except TrainCount must reflect the current Smpl/sec state. To be safe, use a SmplSec command to set the desired mode before using this command.

See also Modulating Burst Values, Burst Dialog, Waveform Stream Controls.