PM Modulator Phase
Macro: PMmodPhase
Controls the phase of the Sine modulator, independent of
the main wave (carrier) Phase. This is particularly
useful if you have set PM Sync, and want to adjust the
display sync point relative to the modulator cycle.
Macro Notes:
L.1.PMmodPhase=90 sets Left Stream 1 PM/Slope/PWM
Modulator Phase to 90 degrees. Alternatively,
PMmodPhase=>1 increments or PMmodPhase=>-1
decrements the current Modulator Phase by 1 degree.
Only +/-1 degree steps are allowed with this command format.
See also Phase / Slope / Width Modulation,
PM / Slope / PWM Dialog,
Waveform Stream Controls
|