Pulse A Level

Controls: Gen Dlg >> Stream >> Wave >> Pulse >> A Level
Macro: PulseAlevel

Sets the level of Pulse A. The default is +100%, with B Level at -100% for a biphasic pulse that starts positive. If you want a biphasic pulse that starts negative, just reverse these values.

If you set A Level to 0 (or to the 0 Level value) you will get a delayed Pulse B. Use A Width to adjust the delay time.

There is nothing to prevent you from setting both A Level and B Level to the same polarity. There is probably no reason to set identical levels, since you would simply get one longer pulse that required two different Width adjustments. But you might want to set different levels to get a two-step pulse.

Macro Notes:

L.1.PulseAlevel=50 sets the Left Stream 1 Pulse A Level to 50%.

Note that setting Pulse values directly via macro does not automatically set the Wave to Pulse. Use Wave=Pulse to do that.

See also Wave Dialog, Pulse Wave.