Data AcQuisition And Real-Time Analysis
Scope - Spectrum - Spectrogram - Signal Generator
Software for Windows
Science with your Sound Card!
The following is from the Daqarta Help system:



Spectrum Analyzer

Signal Generator

(Absolutely FREE!)


Pitch Tracker


DaqMusiq Generator
(Free Music... Forever!)

Engine Simulator

LCR Meter

Remote Operation

DC Measurements

True RMS Voltmeter

Sound Level Meter

Frequency Counter
    Spectral Event

    MHz Frequencies

Data Logger

Waveform Averager


Post-Stimulus Time
Histogram (PSTH)

THD Meter

IMD Meter

Precision Phase Meter

Pulse Meter

Macro System

Multi-Trace Arrays

Trigger Controls


Spectral Peak Track

Spectrum Limit Testing

Direct-to-Disk Recording



Frequency response

Distortion measurement

Speech and music

Microphone calibration

Loudspeaker test

Auditory phenomena

Musical instrument tuning

Animal sound

Evoked potentials

Rotating machinery


Product test

Contact us about
your application!


Controls: Sgram/PT Dialog >> Pitch-to-MIDI >> Setup
Changes: nv=n

After Pitch Track notes reach a given MIDI Voice Setup, various Range and Scale operations may be performed that can select or adjust which note will be played. The +/-Note control adds a final (usually... but see below) adjustment that shifts the overall note up or down by a specified number of MIDI notes (semitones).

You can set +/-Note so that one voice tracks another at a fixed pitch distance. For example, if you set +/-Note on one voice to 0, another to +4, and yet another to +7, assuming the voices have the same Range and Scale settings, they will form a tracking major chord... even if they use different instruments. (If you want a tracking chord using the same instrument, it is much easier to do with the Chord Pattern.)

Or +/-Note can be used to shift the performance pitch range, so that a piccolo input is performed in the tuba range.

The +/-Note setting behaves differently if Note PreScale is active. In that case, +/-Note is applied before Scale, allowing Scale to choose the nearest note that fits the selected scale. This typically leads to a different sequence of notes, compared to the non-PreScale operation.

Note: The +/-Note control is disabled when Tempo Mode is set to Percussion, since incoming notes are ignored.

MIDI Changes Script:

Use nv=n to set +/-Note for Voice v to the value of n, which may be any signed integer or valid expression, including current MIDI control values, random values, current computer keyboard states or mouse position, input or buffered notes, or oscillators. Values will be limited to a +/-63 note range.

For example, n2=-12 will set Voice 2 an octave (12 semitones) lower.

You can use "voice" 9 to set all 8 voices at once.

See also MIDI Voice Setup Dialogs, Pitch-to-MIDI dialog, Pitch Track Toolbox - Overview


Questions? Comments? Contact us!

We respond to ALL inquiries, typically within 24 hrs.
Over 35 Years of Innovative Instrumentation
© Copyright 2007 - 2023 by Interstellar Research
All rights reserved